JVC RX-884RBK manual Connecting the Power Cord, To shut off the power completely

Getting Started

English

Connecting the Power Cord

Before plugging the receiver into an AC outlet, make sure that all connections have been made.

Note:

The preset settings such as preset channel and sound

1.Plug the power cord into an AC outlet.

2.Press POWER to set it in the _ON position.

The STANDBY lamp lights up. A small amount of power is always consumed.

To shut off the power completely

Press POWER to set it in the ÑOFF position.

POWER

_ ON Ñ OFF

adjustment may be erased in the following cases:

–When you press POWER to set it in the ÑOFF position.

–When you unplug the power cord.

–When a power failure occurs.

CAUTIONS:

Keep the power cord away from the connecting cables and the antenna. The power cord may cause noise or screen interference. We recommend that you use a coaxial cable to connect the antenna, since it is well-shielded against interference.

The difference between the POWER switch and the STANDBY/ON button

•The POWER switch is the mains supply switch, allowing the receiver to connect to the mains supply. To shut off the power completely, press the POWER switch to set it in the ÑOFF position.

•The STANDBY/ON button is a functional on/off (standby) switch, and does not disconnect the receiver from the mains supply. A small amount of power is consumed even in standby mode for the receiver to accept signals from the remote control.

•Do not touch the power cord with wet hands.

•Do not pull on the power cord to unplug the cord. When unplugging the cord, always grasp the plug so as not to damage the cord.

Putting Batteries in the Remote Control

Before using the remote control, put two supplied batteries first. When using the remote control, aim the remote control directly at the remote sensor on the receiver.

1.On the back of the remote control, remove the battery cover as illustrated.

2.Insert batteries. Make sure to observe the proper polarity: (+) to (+) and (–) to

(–).

3.Replace the cover.

R03 (UM-4)/AAA (24F)

-	+
+
-

If the range or effectiveness of the remote control decreases, replace the batteries. Use two R03 (UM-4)/AAA (24F) type dry-cell batteries.

CAUTION:

Follow these precautions to avoid leaking or cracking cells:

•Place batteries in the remote control so they match the polarity indicated: (+) to (+) and (–) to (–).

•Use the correct type of batteries. Batteries that look similar may differ in voltage.

•Always replace both batteries at the same time.

•Do not expose batteries to heat or flame.

13