JVC RX-E100SL manual Basic Settings, 1Press SETTING

Dynamic Range Compression — D.R.C.

You can compress the dynamic range (difference between maximum sound and minimum sound) of the reproduced sound. This is useful when enjoying surround sound at night.

•This function takes effect only when playing back a source using Dolby Digital.

Before you start, remember...

There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

Low Frequency Effect Attenuator — LFE

If the bass sound is distorted while playing back software using Dolby Digital or DTS Digital Surround, follow the procedure below.

•This function takes effect only when the subwoofer (LFE) signals come in, (with “SUBWFR” set to “YES”).

Before you start, remember...

There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

1Press SETTING.

Basic Settings

1Press SETTING.

The CONTROL buttons now work for basic

SETTING

settings.

SETTING

The CONTROL buttons now work for basic settings.

2Press CONTROL°(or 5) repeatedly until “D.R.C. (Dynamic Range Compression)” (with the current setting)* appears on the display.

CONTROL

IC

TO

T VOL

*“MID” is the initial setting. If you have already changed the setting, another setting will be shown.

3Press CONTROL 3 (or 2) to select the appropriate compression level.

•Each time you press the button, the compression level changes as follows:

CONTROL
ANALOG	L	C	R	PRO LOGIC
LPCM	SUBWFR LFE			DSP
DOLBY D	LS	S	RS	DGTL AUTO	VOL
DTS				INPUT ATT

2Press CONTROL °(or 5) repeatedly until “LFE (Low Frequency Effect)” (with the current setting)* appears on the display.

CONTROL

C

O

VOL

*“0” is the initial setting. If you have already changed the setting, “–10dB” will be shown.

3Press CONTROL 3(or 2) to select the LFE attenuator level.

•Each time you press the button, the LFE attenuator level changes as follows:

CONTROL
ANALOG	L	C	R	PRO LOGIC
LPCM	SUBWFR LFE			DSP
DOLBY D	LS	S	RS	DGTL AUTO	VOL
DTS				INPUT ATT

OFF : Select this when you want to enjoy surround with its full dynamic range. (No effect applied.)

MID : Select this when you want to reduce the dynamic range a little.

MAX : Select this when you want to apply the compression effect fully. (Useful at night.)

0dB : Normally select this.

–10dB : Select this when the bass sound is distorted.

15