How to Use the External Control
7About the External Control
The Monitor has the MAKE/TRIGGER terminal, which allows you to control the monitor by the MAKE (make contact) or TRIG. (trigger) system selected in the function setting.
MAKE (make contact) system: Controls the function by
TRIG. (trigger) system: Controls the function by inputting the pulse signal instantaneously to the corresponding pin terminal.
*Select “MAKE” or “TRIG.” from “REMOTE SYSTEM” in
NOTES:
•The external control has priority over operations using front panel buttons or menu functions of the monitor.
•When using the make contact system, you cannot use the functions which are applied to the MAKE/TRIGGER terminal operating the front panel buttons or the menu of the monitor. (When using the trigger system you can also use those functions operating the monitor directly.)
7How to Use the MAKE/TRIGGER Terminal
7Function of the MAKE/TRIGGER terminal
The following are the configurations and the functions of the pin terminals of the
7To change the functions applied to the pin terminals
1. | Display |
| VOLUME control to / to select “REMOTE |
| SYSTEM,” then move it to . |
2. | Move the MENU/VOLUME control to / to select |
Caution: |
This is a female
connector.
NO. |
| Functions to be controlled |
1 | INP. A | Changes the input to INPUT A |
|
|
|
2 | INP. B | Changes the input to INPUT B |
|
|
|
3 | CO. OFF | Turns on/off COLOR OFF |
|
|
|
4 | ASPECT | Changes ASPECT |
|
|
|
5 | TALLY | Controls the tally lamp |
|
|
|
6 | STATUS | Turns on/off the status display |
|
|
|
7 |
| External control |
|
|
|
8 |
| GND |
|
|
|
“CONTROL FORM,” then move it to | / | to select |
“SET.” |
|
|
3. Move the MENU/VOLUME control to | / | to select |
the number of the pin terminal (PORT F1 – PORT | ||
F6) you want to set, then move it to | / | to select |
the function. |
|
|
NOTE:
• You cannot apply two or more functions to one terminal.
14
