JVC TM-1011G manual e AC power switch, r Composite signal input/output terminals VIDEO A, VIDEO B

eAC power switch

Turns the AC power on and off.

• I : on ◯ : off

NOTE:

•You need to turn on the stand-by button on the front panel to turn on the monitor after turning on the AC power switch.

rComposite signal input/output terminals (VIDEO A, VIDEO B)

Input (IN) and output (OUT) terminals for the composite signals of the NTSC, PAL, and B/W (50 Hz/60 Hz).

NOTES:

•NTSC and PAL are switched in the “COLOR SYSTEM.”

☞“COLOR SYSTEM” on page 12

•The IN and OUT terminals are bridge-connected (auto termination).

tAnalog audio signal input/output terminals (AUDIO A, AUDIO B)

Input (IN) and output (OUT) terminals for the analog audio signals.

NOTE:

• The IN and OUT terminals are bridge-connected.

yREMOTE (external control) terminals

Terminals for controlling the monitor by an external control.

☞ “How to Use the External Control” on pages 14 and 15

uDC switch

Turns the DC power on and off.

• I : on ◯ : off

NOTES:

•You need to turn on the stand-by button on the front panel to turn on the monitor after turning on the DC switch.

•The monitor consumes the battery even while the monitor is on stand-by. To save battery life, turn off the DC switch on the rear panel.

•While you operate the monitor with the DC power supply, the built-in degaussing circuit does not work. If the monitor has become magnetized, switch the power supply to AC so that the built-in degaussing circuit works or use an external degausser.

7