1FTP
To use the FTP function, select [Available].
2User Name
Enter the user name to use for verification with the FTP server. It can be Òanonymous.Ó
3Password
Enter the password to use for verification with the FTP server. The password is displayed as asterisks (*).
4FTP Server IP Address
Enter the IP address of the upload destination FTP server.
5FTP Port
Enter the FTP port number of the upload destination. This is normally set to Ò21.Ó
6FTP Folder
Enter the folder name on the upload destination FTP server. If this box is left blank, images are uploaded to the default folder.
7Upload Interval
Specify the upload interval at which images are uploaded to the FTP server (0 to 84600 seconds).
If [Disconnect every time] is selected, connection with the FTP server is cut after an image was uploaded.
8Error Recovery (Connection error)
Specify a recovery action when an error occurred for TCP connection or FTP
verification of
❈min. Retry
(Transfer error)
Select a recovery action when a transfer error occurred in uploading an image.
FTP Disabled: The FTP function is automati- cally disabled.
Note
To enable the function again, select [Avail- able] for [FTP].
9Filename
*.jpg : If this file type is selected, uploading is performed with the entered file name.
Note
Only one image file is stored in the FTP server as files are overwritten with the lat- est one.
Time stamp : Files are uploaded with the time of the
Note
●Set the correct time in the [Time Set- ting] screen.
●All uploaded image files are stored in the FTP server.
35