4 Select [Remove Flash Memory].

•You will be asked to confirm that you want to remove the flash memory. Click the [OK] button.

•A message informing you that the flash memory has been removed will be displayed. Click the [OK] button.

5 Remove the flash memory from the SERIAL port on the front or rear panel.

Note

•Settings data is saved to the VR-N900 folder in the flash memory (USB memory).

•If you want to save additional settings data after selecting [Remove Flash Memory], remove the flash memory from the serial port, then insert it again. When the flash memory is inserted, it will be automatically detected.

●[Load Setting Data]

This lets you read settings data from the flash memory.

1 Insert the flash memory into the SERIAL port on the front or rear panel.

2 Select [Load Setting Data].

•If data has been saved to the flash memory, a list of the data that has been saved will be displayed in the settings data list.

•A message informing you that the flash memory cannot be detected may be displayed. If this happens, wait approximately 30 seconds, then select [Load Setting Data] again.

•Settings data that has been saved on this VR-N900U will be preceded by My Machine. If the data was saved on another VR-N900U, it will be preceded by Other Machine. This will be followed in parenthesis by the MAC address of the VR-N900U at the time the data was saved. This in turn will be followed by the date/time when the data was saved in the form [yyyy – mm – dd – sec – Setting].

•If several data are displayed, highlight the data in the list that you want to read.

[Setting Data List] window

3 Select [Load], then click the [ZOOM IN/ENTER] button on the front panel.

The highlighted data will be read.

4 You will be asked to confirm that you want to read the settings data. Click the [OK] button.

•The settings data will be read.

•When reading is finished, a message informing you that the data has been read will be displayed. Click the [OK] button again.

5 Click the [Close] button. You will be returned to the [Flash Memory Utility] window.

6 Select [Remove Flash Memory].

•You will be asked to confirm that you want to remove the flash memory. Click the [OK] button.

•A message informing you that the flash memory has been removed will be displayed. Click the [OK] button.

7 Remove the flash memory from the SERIAL port on the front or rear panel.

Note

•Items specified in [Screen Setup], [Camera Record Setting] and [Image Server Setting] in the Main Menu will not be read.

•If you want to read additional settings data after selecting Remove flash memory, remove the flash memory from the serial port, then insert it again. When the flash memory is inserted, it will be automatically detected.

61