2 Left click and drag the mouse pointer over the grid sections in the preview image to select the areas in which motion detection will be disabled.

Selected areas are highlighted in blue.

To clear areas in which motion detection has been disabled, right click and drag the mouse pointer over the required grid sections.

Buttons and Check BoxesSet All:Lets you quickly select all grid sections in the preview image.Clear All:Lets you quickly clear all grid sections in the preview image.Auto:

By clicking the [Auto] button, the system will automatically detect areas with noise (insignificant changes in individual pixels which should not be regarded as motion) in the image, and automatically mark such areas as areas in which motion detection should be disabled. As the automatic detection is based on an analysis of a number of images, it may take a few seconds from after you click the [Auto] button until noisy areas are detected and marked.

Show grid:

With the [Show grid] check box selected, the preview image contains a grid indicating the division of the preview image into selectable sections. By default, the [Show grid] check box is selected.

CAUTION

•When the motion detection is set at short intervals, note that the number of alarm will increase and reach to the point where time is required to search for playback.

•When the camera is connected, malfunction of the motion detection may occur due to the flickers of fluorescent lamps, etc. In this case, set the camera to the flicker less.

•When there are a lot of noise included in camera image, there may be a false detection. Set the camera not to false detect, even when the ACG of the camera at nighttime, etc. is operating.

Other Settings

General Settings

The [General Settings] window lets you manage a number of settings such as e-mail settings, etc. To access the [General Settings] window, click the [General Settings] button in the [Camera Record Setting] window.

[General Settings] window

●Milestone XProtect Central Settings Section

Settings for using Milestone XProtect Central made by Milestone Systems. For detailed information, please refer to Central 3.1 Administrator's Manual.

(http://milestonesys.com/?cid=265)●[Patrolling Settings] Section

Specify the settings in this section when using PTZ cameras for which patrolling has been set up. (☞Page 45)

●[Event Recording Settings] Do not change these settings.●[Advanced Settings] Section Don’t send e-mail on camera failures:If selected, no e-mail alerts will be sent if contact is lost with a camera.Start cameras on remote live request:

You are able to view live images from cameras even though the cameras in question are offline.

When a live image of VR-N900 Viewer is displayed, the camera automatically changes to online and records the image according to the recording settings.

CAUTION

•The cameras will be online when [Start cameras on remote live request] is set and live images are displayed. The display of live images in the recording control mode combined with certain settings may start recording. This is also the case when live images appear on a surveillance computer.

55