LNB-supply voltage, Audio connection | Kathrein UFD 505 manual

Operating instructions

LNB-supply voltage

If the feed system (LNB) is powered by an external supply voltage and the LNB supply voltage is not used for switching over polarity (e.g. Kathrein feed system UAS 330), the LNB supply of the receiver must be set to "OFF" (see section "Installation menu, LNB configuration“).

TV and video recorder connection

Use a SCART cable to connect the satellite receiver (TV SCART) and TV set.

If your TV set is equipped for stereo output, you can receive the sound in stereo via the SCART connection.

Also use a SCART cable to connect the satellite receiver (VCR/AUX SCART) and the video recorder.

Audio connection

If you wish to reproduce the sound via a hi-fi system, connect a corresponding Cinch cable from the audio Cinch sockets on the receiver to the input sockets on your hifi system.

The digital output is designed to facilitate connection to a Dolby Digital System.

Inserting batteries in the remote control

Remove the cover on the battery compartment on the underside of the remote con- trol.

Insert the two supplied batteries in the remote control. Ensure correct polarity of the batteries, the + and – markings are indicated inside the battery com- partment.

Slide the cover back into the casing and lock in position.

Used batteries are special waste! Therefore do not throw batteries into the house- hold waste but rather deposit them at a collection depot for old batteries!

15

Image 15

Kathrein UFD 505 manual LNB-supply voltage, TV and video recorder connection, Audio connection

Contents

Order no Page Important Notes Safety Instructions First time operation Oscillator frequency L.O Changing the oscillator frequency Remote frequency Important notes regarding operation Operating elements, displays and connections View of front panel View of rear panelFlap folded down Remote control handset keys Connection and putting into operation Second receiver on the command set Menu concept Button functionsAlphanumeric entries Language selection- OSD Operating instructions Sat-IF connection Preconditions for receiving digital signalsPresetting of receiving system To connect receiver Audio connection Inserting batteries in the remote controlLNB-supply voltage TV and video recorder connection First steps Factory setting of receiver Important on-screen displays Programme selection Selecting a TV programme Radio programme listReception status Reception status radio Switching over to radio programmeOn-screen displays On Screen Display Selecting a TV programme by number entry Selecting a radio programme by number entry VPS signal Timer-settings EPG timer programming Programme overviewFull EPG Mute Sound settingsSetting the volume Stereo and two-channel sound reproduction Programme lists Selecting programmes last receivedFavourite programmes To delete a programme To sort the channels To add a programme manually Incorrect parameter To remove satellite Setting up a satelliteSatellites add/remove To enter a name Parental lock PasswordFactory setting Entering a password Same accounts for transponder exchange Operation from the front panel Backup operation System parameters Setting system parameters Screen Summer timeTV type Picture format OSD trans OSD colour Installation menu LNB configuration10,7…11,7 GHz Low-band Low-band / analogue transmis Sion Changing the oscillator frequency Satellite search Antenna settings Transponder selection TP set-up/search DiSEqC UFO Set-up Error KHz signal High/Low Pos. A/B Tone Burst Tone burst Opt. A/B Factory setting Playback Recording „Display info Preparation Transferring programme listsTransferring operating software Technical features Technical annex Technical data Scart socket assignments Accessories Connection arrangement Connection examples VHF/UHF VCR LNB Programme package Short technical lexiconDiSEqC components Eb/No ratio Viterbirate Symbol rateTransponder Video bit rate Service SatelliteDiSEqC menu 998.6246/1001/ZWT/ Subject to technical changes