Kathrein UFD 505 manual KHz signal High/Low Pos. A/B Tone Burst Tone burst Opt. A/B

Installation menu

Tone burst

Under this menu point, the 22 kHz signal can be set as follows:

Switching statuses of setting:				Switching statuses of setting:
22-kHz signal		—> High/Low		22-kHz signal		—> Pos. A/B
		and				and
Tone Burst		—> Pos. A/B:		Tone burst		—> Opt. A/B
Low		22-kHz	Off	Pos	Tone burst		22-kHz
High		22-kHz	On
				1		0	Off
Pos. 1	Tone burst		0	2		0	On
Pos. 2	Tone burst		1	3		1	Off
				4		1	On

Switching statuses of setting:

22-kHz signal		—> Pos. A/B
		and
Tone Burst		—> High/Low
Low	Tone burst		0
High	Tone burst		1
Pos. 1		22-kHz	Off
Pos. 2		22-kHz	On

DiSEqC

If the receiver is connected to a DiSEqC switchover matrix, you will need to set this menu point to ON.

The switching criteria and the input assignments of the DiSEqC switching matrix must be maintained. Therefore, refer to the description of the switching matrices or contact the installer of the receiving system.

DiSEqC Repeat

The DiSEqC command must be repeated if the receiver is operated (cascaded) to- gether with a receiving system with two or more series connected DiSEqC switch- ing matrices.

In this case, switch the menu point "DiSEqC repeat" to 1 or 2. Factory preset: OFF

UFO mini

The input frequency of the receiver is fixed in a "user-controlled processing sys- tem". The signals from the "user-controlled processing system" are transmitted on this frequency. The reception parameters for programme selection are transferred to the receiving system by means of a DiSEqC command and set accordingly.

The relevant setting that needs to be selected depends on the type of "user-con- trolled processing system".

The setting should be made according to the data provided in the installation in- structions for the "user-controlled processing system".

Remote frequency

If you have set the UFO mini menu point to ON, you will need to set the transmis- sion frequency under this menu point.

Refer to the installation instructions of the "user-controlled processing system" for the set transmission frequency.

It is therefore important that you refer to the information provided in the installation instructions of the "user-controlled processing system".

UFO micro

The setting under this menu point is also designed for operation of the receiver to- gether with a processing system.

Control and communication between the receiver and the Kathrein UFO micro sys- tem takes place on the return of the coaxial cable.

ON must be set under the UFO micro menu point if the receiver is operated to- gether with a UFO micro receiving system.

During installation, the receiving system then assigns a special address to the re- ceiver so that the control instructions that are sent from the receiver to the receiv- ing system for signal selection are also recognised by this system.

40