Installation menu
Changing the oscillator frequency
Move over to the
the LO Low setting. Press the buttons to go to this setting.
Press the 4 times to exit the menu. At the same time, the receiver will confirm that the values have been saved.
If a setting is incorrect, you will see the following message on the screen
Bad or no signal
Operation
Factory setting "ON".
Normally, the supply voltage should always be switched on.
For communal or party systems, you must check whether the supply voltage must be switched off!
Standby
Under this menu point the supply voltage for the LNB in receiver standby mode can be switched on and off. It can be switched off for individual and communal sys- tems. The factory setting is "OFF".
Receiving two satellites
If your receiver is connected to a multifeed antenna that is also aligned with the HotBird satellites for instance, you will need to change the receiver settings for the DiSEqC signal. The same, of course, also applies to other satellites. (DiSEqC = Digital Satellite Equipment Control).
Different control signals are required for the purpose of selecting the satellite sig- nals. To date, the LNB supply voltages 14/18 V and the 22 kHz signal (superim- posed on the LNB supply voltage) have been sufficient for signal selection in the majority of applications. With these four switching signals it is possible to switch be- tween horizontally and vertically polarised signals as well as between satellites (multifeed reception).
However, additional control signals are now required for LNB activation and signal selection in view of the expansion of the frequency range to 12 GHz
The "DiSEqC" control signal is responsible for this task. This signal represents a special modulation of the already existing 22 kHz signal.
36
