FIRST INSTALLATION: Single-cable system (Manual)

Press the  button to confirm.

Press (if necessary several times) the ! (green) button until you reach the “Channel list selection” point.

Continue the first installation with the “Search” section.

MANUAL

Press the  button to confirm and check your settings. If necessary, seek assistance from a specialist engineer.

Use the  button to switch to the “Test

connection” line again and press the  button. As soon as the receiver outputs the “Connection OK” message, you can continue as described on the left.

Connected equipment:

Select the single-cable components used in your system using the  buttons. Available options: Kathrein 2 subscribers (EXR 552), Kathrein 4 subscribers (EXR 501, EXR 551), Kathrein 8 subscribers (EXR 1581, EXR 2581, EXU 908) or User defined (UAS 481).

We have selected the UAS 481 single-cable LNB as an example for the remainder of this explanation. If there are differences to other components or to the setting “User defined”, we will note and explain these differences.

Transmission channel:

Press the  button to switch to the “Transmission channel” line. Select the required transmission channel using the  buttons.

If one or more receivers are already present on the system and an additional receiver is to be connected, you must assign a different frequency (transmission channel) to the new receiver (otherwise the receivers will interfere with each other).

19

Page 19
Image 19
Kathrein UFS 790si, UFS 790sw manual First Installation Single-cable system Manual