Kathrein UFS 790sw, UFS 790si manual FIRST INSTALLATION Single-cable system Manual

FIRST INSTALLATION: Single-cable system (Manual)

Transmission frequency (only with the selection “User defined”):

Use the  button to switch to the “Transmission frequency” line and enter the appropriate transmission frequency using the number pad. You can find the necessary information (transmission frequencies) in the documentation supplied with your system.

You can only use the “Secure channel with PIN” function if this function is supported by the single-cable components used. In the case of Kathrein single-cable components, this is currently only the case for the EXU 908.

Secure channel with PIN:

Press the  button to switch to the “Secure channel with PIN” line. Here it is possible to protect the transmission frequency used by entering a PIN. No other receiver can then use that transmission

frequency unless the PIN is input. Select the setting “Yes” using the  buttons.

Password PIN (only for “Yes” setting in the “Secure channel with PIN” line):

Select the “Password PIN” line using the	 button. You can now use the number pad to enter
a PIN (0-255).

Testing connection:

Use the  button to switch to the “Test connection” line and press the  button. The receiver now tests the settings you have made. The following message appears:

Press the  button to confirm.

Press (if necessary several times) the ! (green) button until you reach the “Channel list selection” point.

Continue the first installation with the “Search” section.

Press the  button to confirm and check your settings. If necessary, seek assistance from a specialist engineer.

Use the  button to switch to the “Test

connection” line again and press the  button. As soon as the receiver outputs the “Connection OK” message, you can continue as described on the left.

20