CONNECTION AND SETUP

RF(HF) CONNECTION

Connect the RF input on the receiver to the antenna socket or your DVB-T antenna.

Use the antenna cable supplied for this purpose, or a coaxial cable with an IEC standard connector. If the IEC connector is not yet fitted to this cable, strip the insulation from the cable as shown in the following illustration and carefully twist the connector onto the end of the cable until it is securely fitted to the cable.

 

 

 

 

 

Screw together

Lengthwise slits (3x)

 

Bend back

When fitting the connector, make sure that no strands from the braiding touch the inner conductor, otherwise a short circuit may occur.

The quality of the reception signal depends on this connection!

TV CONNECTION

Connect the satellite receiver (TV Scart socket) to the TV set with a Scart cable. If your TV is stereo, you can receive the sound in stereo via the Scart connection. Connect the satellite receiver to the video/DVD recorder with a Scart cable.

INSERTING BATTERIES IN THE REMOTE CONTROL

Remove the cover on the rear of the remote control.

Insert the two batteries supplied into the remote control. Ensure correct polarity of the batteries; the

+and - markings are indicated inside the battery compartment. Slide the cover back into the housing until it locks in place.

9

Page 9
Image 9
Kathrein UFS 790si, UFS 790sw manual Rfhf Connection, TV Connection, Inserting Batteries in the Remote Control