Floor drain system (view D)
The floor drain system requires a siphon break that may be
purchased separately. See "Tools and Parts."
The siphon break must bea minimum of 28" (71 cm) from the
bottom of the washer. Additional hoses might be needed.
C D
Electrical Shock Hazard
Plug into a grounded 3prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
• A 120 volt, 60 Hz., AC only, 15- or20-amp, fused electrical
supply is required. A time-delay fuse orcircuit breaker is
recommended. It is recommended that a separate circuit
serving only this appliance be provided.
• This washer is equipped with a power supply cord having a
3 prong grounding plug.
To minimize possible shock hazard, the cord must be
plugged into amating, grounded 3 prong outlet, grounded in
accordance with local codes and ordinances. If a mating
outlet is not available, it isthe personal responsibility and
obligation of the customer to have the properly grounded
outlet installed by a qualified electrician.
• If codes permit and aseparate ground wire is used, it is
recommended that a qualified electrician determine that the
ground path is adequate.
• Do not ground to a gas pipe.
• Check with aqualified electrician if you are not sure the
washer is properly grounded.
• Do not have afuse in the neutral orground circuit.

GROUNDING iNSTRUCTiONS

For a grounded, cord-connected washer:
This washer must be grounded. Inthe event of a malfunction
or breakdown, grounding will reduce the risk of electrical
shock by providing apath of least resistance for electric
current. This washer is equipped with a cord having an
equipment-grounding conductor and agrounding plug. The
plug must be plugged into an appropriate outlet that is
properly installed and grounded in accordance with all local
codes and ordinances.
WARNING: Improper connection of the equipment-
grounding conductor can result ina risk of electric shock,
Check with a qualified electrician or serviceman if you are in
doubt as to whether the appliance is properly grounded,
Do not modify the plug provided with the appliance - if it will
not fit the outlet, have a proper outlet installed by a qualified
electrician.
For a permanently connected washer:
This washer must be connected to agrounded metal,
permanent wiring system, or an equipment grounding
conductor must be run with the circuit conductors and
connected to the equipment-grounding terminal or lead on
the appliance.
INSTALLATION INSTRUCTIONS
Excessive Weight Hazard
Use two ormore people to move and install washer.
Failure to do so can result in back or other injury.
NOTE: To avoid floor damage during installation, set the washer
onto cardboard before moving across floor.
IMPORTANT:
• Be sure the foam shipping base has been removed from the
bottom of the washer as directed in the Unpacking
Instructions.
• If foam shipping base has not been removed, be sure lid is
secured with tape before laying washer on its back.
• Removing the foam shipping base is necessary for proper
operation.
1. Place cardboard supports from shipping carton on floor
behind washer for support.
2. Secure the lid with tape.
6