Kenmore 110.2806, 110.2807 manual Abc

1, Drape the power cord over the console.

2.Remove any cardboard used to move washer.

Beaded tie strap

3.Fasten the drain hose to the laundry tub leg or drain standpipe with the beaded tie strap. See view A or B.

3.Lower right front foot until it contacts the floor. By hand, firmly rotate foot as much as an additional 11/=turns. The other three

feet have been preset at the factory.

4.Check the levelness of the washer by placing a level in the crease between the top of the washer and the cabinet, first on the front and then on the side.

ABC

If the washer faucets and the drain standpipe are recessed, put the formed end of the drain hose into the standpipe.

Tightly wrap the tie strap around the water inlet hoses and the drain hose. See view C.

Excessive	Weight	Hazard
Use two or more people to	move	and	install	washer,
Failure to do so can result	in back	or	other	injury,

One washer foot has been installed at a different height on your new washer. The other three feet were preset at the factory. Properly leveling your washer will minimize noise and vibration.

1.Slide the washer to its final location.

2.Push on upper front panel to be sure the washer is on its rear feet.

Level the fronL

Level the side.

5.If the washer is not level, move the washer out slightly, tip back, prop up the front of the washer on a wood block. Adjust the feet up or down as necessary by twisting the feet. Repeat steps 1 through 4 until washer is level.

6.Use a 9/16"or 14 mm open-end wrench to turn the Iocknut counterclockwise on the foot tightly against the washer cabinet.

IMPORTANT: If the Iocknut is not tight against the washer cabinet, the washer may vibrate.

9