Kenmore 9, 11, 5, 7, 3 manual Main Jackshaft Bearing replacement, PTO Shaft SET- UP

MAINTENANCE

Main Jackshaft Bearing replacement.

		IMPORTANT
The Bearing Shims must be replaced exactly as
	removed, if the Jackshaft Bearings are removed.
Fig.38
If the Jackshaft Bearings are replaced, the Jackshafts
alignment must be checked and re-set.
The shafts are aligned, fore and aft, with Shims behind the
bearings, and vertically with slotted holes in the bearing
flanges.
	• Assemble the Shafts, Sheaves and Bearings with
	Lock Collars, and Shims in place as removed.
	• Tighten the Bearing Bolts, and with a Straight
	Edge across the front of the Shafts, check the ‘fore
	and aft’ alignment.
	Add or remove Shims as necessary.
	• Place the Straight Edge on top of the Shafts.			Fig.38
	Back-off the Bearing Bolts and adjust the Bearings
	‘up or down’ to align the shafts.
PTO SHAFT SET- UP
Fig.39
The Inner and Outer PTO Shafts are ‘keyed’ to the
Jackshafts. If the Bearings are replaced the shafts the
shafts must be set-up as illustrated.
41			Fig.39