6.For Natural Gas grills:
Connect the Electric Wire terminal from Side Burner
with the other from Grill Head. See Figure 8d. Bind the connected Electric Wires, and Connection Tube
together using the supplied Fastening Band.
7.The gap between the Side Burner Electrode Tip and the Side Burner Port should be approximately 1/8"~3/16". See Figure 8e. If the gap is wider than 3/16", use a pair of long nose pliers and gently bend the Electrode Tip toward the Burner.
8.Slide the 5 Tool Hooks onto the Tool Holder with hooks facing the grill Head. Attach Tool Holder to left side of Side Shelf and secure firmly using 2 of the M5x8mm Pattern Head Screws and washers supplied. See Figure 8f.
•When you have finished assembling your grill we strongly urge that all Pattern Head Thumb Screws be tightened, either with the supplied Tightening Tool or a #2 Phillips Head Screwdriver.
Tightening Tool
Ref. # P05515102K
Figure 8d (Natural Gas model only)
SIDE BURNER POT SUPPORT
\\\\\
_StDBBURNER
|
|
| COTTER PIN | |
|
| \ |
|
|
CONTROL |
| SiDE BURNER | FRAME | |
|
| |||
KNOB_ |
|
|
|
|
| _StDE | BURNER | GAS | |
|
| VALVE | ASSEMBLY | |
FASTENING |
|
|
|
|
BAND | _ | ELECTRIC WIRE | ||
|
| FROM | SiDE | BURNER |
\\
\
ELECTRIC WIRE
FROM GRILL HEAD
Figure 8e
9.For Natural Gas grills:
Connect the hose end of the 12' Natural Gas Hose to the vertical fitting as shown in Figure 8g. Also read the natural gas safety instruc- tions. (on page 4)
Figure 8g (Natural gas model only)
BRASSADAPTOR, | f | SIDE BURNER | GAS VALVE |
12'NATURAL GAS HOSE
CONNECTION TUBE
FROM GRILL HEAD
FOOT\SIDE BURNER
Figure 8f
TOOL HOOK
TOOL HOLDER
M5x8rnm PATTERN
HEAD SCREW
SiDE SHELF
18
