[] Ignitor Battery Installation - See Fig. 9
1.Remove the Ignitor Caps on the grill Control
Panel.
2.Place the manufacturer supplied AA battery into Ignitor Slot. Be sure to place the positive pole facing toward you. See Figure 9.
3.Place the Cap and Spring over the AA battery then tighten the Ignitor Cap back onto the grill Control Panel.
4.Remove any protective film from outside and inside of Grill Head.
IMPORTANT: Before use of this grill please refer to Cleaning Exterior Stainless Steel
Surfaces found on page 27 of this Owner's Manual.
Figure 9
IGNITOR SLOT
[] Electrode Check - Requires an Assistant
Before placing the cooking components into your grill, ensure that the Spark Electrode Tip is properly
positioned within each Gas Collector Box ( a
1.Be sure all Control Knobs are set to "OFF" and open the Grill Lid.
2.Have an assistant stand behind to the right of the grill and look down at each Gas Collector Box. NEVER put your face inside Grill Head.
. Press the Ignitor Cap. You should hear a "clicking" sound and your assistant should see a small blue spark within each Gas Collector Box. If a spark is present the Electrode Tips are properly positioned.
4.if no spark is seen the Spark Gap shown in Figure 10 needs to be adjusted as follows:
Using an adjustable wrench, loosen the inside Nut just until the Gas Collector Box can be maneuvered and turned upward.
The gap between the Spark Electrode Tip and Spark receiver should be approximately 3/16".
If the gap is wider than 3/16" use a pair of long nose pliers and gently squeeze the Gas Collector Box until the gap is correct.
Return the Gas Collector Box to its original
horizontal position, secure the Inside Nut and try the Electrode Check again.
5.If no "clicking" sound is heard check the following
common causes. If you need assistance call our Grill Information Center
at
•IgnitorAA battery not installed properly.
Electric wires may be loose. Remove the AA battery, inspect the Ignitor Junction Box found
behind the Control Panel, and connect any loose wires.
Figure 10 - Side View Figure
GAS COLLECTOR BOX
\\ | iNSiDE NUT |
\
SPARK GAP _SPARK RECEIVER
19
