Kenmore 141.153373, 141.173373 owner manual Fuel Gauge Display Installation, Battery Replacement

[] Fuel Gauge Display Installation. Figure 12a

Open the front Doors of Cabinet. Pull out the LPG Tank Pull-Out Tray. Connect the Wire Plug "A" from Fuel Gauge Display with the Wire Plug "B" from rear of Tank Pull-Out Tray. Unscrew 1/4" x 1/2" Pattern Head Screw(Lower) from Cart Rear Panel and fix Wire Plug "A" into Wire Fastener. Install Wire Fastener to Cart Rear Panel. Tighten securely using the same screw. See Figure 12a.

RIGHT CART LEG

CART REAR PANEL\

\\\\

WiRE FASTENER

Battery Replacement:

1.Stretch your hand behind Control Panel and unscrew the Battery Cover behind the Display Box.

2.Pull out the Battery with electric wire from the Battery Compartment.

3.Replace the used Battery with the new one.

4.Replace the new Battery with electric wire back into Battery Compartment. See Figure 12b.

5.Screw the Battery Cover back to the Display Box.

TANK PULL-OUTTRAY

WiRE PLUG "A"

SIDE BURNER FRAME

FUEL GAUGE DISPLAY

WIRE PLUG "B"

WIRE PLUG "A"

Fuel Gauge Display Operating - See Figure 12c

Press the "CHECK" button to operate Fuel Gauge Dis- play with the Gas Tank mounted in the Tank Pull-Out Tray.

NOTE: Tank must be positioned in tray for Fuel Gauge Display check

1.Fuel Display: Indicates Gas Tank fill level.

2.FuelWarning Display: WhentheGasTankfitl level is on the last row, a warning signal will sound for approximately 3 seconds to warn you that the tank volume is near empty.

3.Battery Warning Display: A low battery warning light will illuminate when the battery voltage drops to a low level. Replace the battery.

NOTES:

1. The Fuel Gauge Display lasts for approximately 20

seconds each time you press the "CHECK _'button.

After 20 seconds, the Fuel Gauge Display turns off

automatically. If you press the button a second time

within 20 seconds, the Fuel Gauge Display will be

turned off manually. If you press the button a sec-

ond time after 20 seconds, the Fuel Gauge Display

Figure 12b

FUEL GAUGE

DISPLAY COVER

DISPLAY BOX

WiRE PLUG "A "j

9V BATTERY

.f

J

BATTERY CONNECTOR

IMPORTANT: When the Gas Tank is removed from the Tank Pull-Out Tray, the fuel gauge display will not operate,

Figure 12c

J FUEL INDICATOR _\

will	work and last for another 20 seconds.
2. The Fuel Gauge Display works only with a tank on
the	Tank Pull-Out Tray. No readout will appear if a
tank is not mounted on the Tank Pull-Out Tray.

BATTERY

_CHECK

BUTTON

FUEL

WARNING

D_SPLAY

WARNING DISPLAY

21