Cleaning The Burner Tubes and Burner Ports
To reduce the chance of FLASHBACK the proce- dure below should be followed at least once a month
in late summer or early fall when spiders are most active or when your grill has not been used for a period of time.
1.Turn all Burner Valves to the full OFF position.
2.Turn the LP gas tank valve to the full OFF position.
3.Detach the LP gas regulator assembly from your gasgrill.
4.Remove the Cooking Grids, FlameTamers, and Grease Trays from your grill.
5.Remove the Cotter Pin from the rear underside of each Burner using a pair of long nose pliers.
6.Carefully lift each Burner up and away from the Gas Valve Orifice.
7.Checking and cleaning burnedventuri tubes for insects and insect nests. A clogged tube can lead to a fire beneath the grill.
8.Refer to Figure 1 and perform one of these three cleaning methods:
Bend a stiff wire, (a lightweight coat hanger works well) into a small hook as shown below. Run the hook through the Burner Tube and inside the Burner several times to remove any debris.
,)
Use a bottle brush with a flexible handle. Run the brush through the Burner Tube and inside the Burner several times, removing any debris.
Regardless of which Burner cleaning procedure you use, we recommend you also complete the following steps to help prolong Burner life.
1.Use a fiber pad or nylon brush to clean the entire outer surface of each Burner until free of food residue and dirt.
2.Clean any clogged Ports with a stiff wire, such as an open paper clip.
. Inspect each Burner for damage (cracks or holes) and if such damage is found, order and install a new Burner. After installation, check to ensure
that the Gas Valve Orifices are correctly placed inside the ends of the Burner Tubes. Also check
the position of your Spark Electrode.
Z WARNING
The location of the Burner Tube with respect
to the Orifice is vital for safe operation. Check to ensure the Orifice is inside the
Burner Tube before using your gas grill. See Figure 2. If the Orifice is not inside the Burner Tube, lighting the Burner may cause explosion and/or fire.
Figure 2
GAS VALVE ASSEMBLY
ORIFICEBURNER TUBE
Use an air hose to force air through each |
|
| |||||
Burner Tube. The forced air should pass |
|
| |||||
debris or obstructions through the Burner |
|
| |||||
and | out | the | Ports. |
|
|
| |
Figure | 1 |
|
|
|
|
|
|
|
|
|
|
| GAS COLLECTOR | BOX |
|
|
|
|
|
| / |
|
|
|
|
|
|
| SPARK ELECTRODE | BURNER | BURNERPORT |
TO | CLEAN BURNER | TUBE, | ASSEMBLY x\\\ |
|
| ||
|
|
| |||||
INSERT | HOOK | HERE |
|
|
| ||
|
| \\ |
|
|
|
|
|
_\\\\\
\
FOOT
COTTERPIN
BURNER TUBE
28
