Grounding Instructions | Kenmore 318205869A instruction

Grounding Instructions

For personal safety, the cooktop must be properly grounded. For maximum safety, the power cord must be plugged into an electrical outlet that is correctly polarized and properly grounded.

DO NOT Operate the cooktop using a 2-prong adapter or an extension cord. If a 2-prong wall receptacle is the only available outlet, it is the personal responsibility of the consumer to have it replaced with a properly grounded 3-prong wall receptacle installed by a qualified electrician.

See the installation instructions packaged with this cooktop for complete installation and grounding instructions.

	Grounding	Do not, under any
	type wall	Do not, under any
	type wall	circumstances, cut,
	receptacle	circumstances, cut,
	receptacle	remove, or bypass
		remove, or bypass
		the grounding
		prong.

Power supply

cord with 3-prong

grounding plug

This appliance is equipped with a 3-prong grounding plug for your protection against shock hazard and should be plugged directly into a properly grounded receptacle. DO NOT cut or remove the grounding prong from this plug.

Avoid fire hazard or electrical shock. DO NOT use an adapter plug, an extension cord, or remove grounding prong from electrical power cord. Failure to follow this warning can cause serious injury, fire or death.

Conversion to Liquefied Petroleum Gas (or L.P. Gas)

This natural gas range is designed to allow for conversion to Liquefied Petroleum (L.P.) Gas.

Only a qualified service agent should perform the L. P. conversion. Contact the local gas provider for conversion. The L. P. Conversion Kit is supplied with this range and is located on the main back of the range. The kit contains installation instructions which must be read before and followed carefully when installing the kit.

Personal injury or death from electrical shock may occur if the range is not installed by a qualified installer or electrician.

To avoid serious injury, any additions, changes or conversions required in order for this appliance to satisfactorily meet the application needs must be made by a qualified service agent.

6

Image 6

Kenmore 318205869A manual Grounding Instructions, Conversion to Liquefied Petroleum Gas or L.P. Gas

Contents

Kenmore Table of Contents Important Safety Instructions When heating fat or grease, watch it closely Where appliance is in use. They should neverWhile using the appliance. Do not let clothing Do not leave children alone-Children should Save These Safety Instructions Grounding Instructions Conversion to Liquefied Petroleum Gas or L.P. Gas Slide-in Range Features Your Slide-in Range Features At a Glance Before Setting Surface Controls Control Locations of the Gas Surface Burners Operating the Gas Surface Controls Setting Surface ControlsSetting Proper Surface Burner Flame Size Flame Size Type of Cooktop Using a wok Surface CookingUse Proper Cookware Removing and Replacing Oven Racks Before Setting Oven ControlsOven Vent Location Arranging Oven Racks Setting Oven Controls Control Pad Functions To Change the Minute Timer while it is in use To Set the Minute TimerTemperature conversion To Set the Clock To Set or Change the Temperature for Baking To Set Control for Continuous Bake or 12 Hour Energy SavingTo Set Control for Oven Lockout Cooking Information Oven Baking To Set the Timed Bake and Delay Start Features When the Set Bake Time Runs Out Setting Oven Controls cont’d To Set for Broiling Broil Rack Position Table Refer to Fig Food category To set Warm & Hold Setting the Warm & Hold FeatureTo Operate the Oven Light To set Warm & Hold to turn on automatically Self-Cleaning Oven Cleaning Self-Clean Time Length Adjusting the Oven TemperatureTo Adjust Oven Temperature General Care & Cleaning Cleaning Various Parts of Your Range General Care & Cleaning cont’d Cleaning the Cooktop, Burner Heads, Caps & Grates3rd To Remove Oven Door Removing and Replacing the Lift-Off Oven DoorDoor Hinge locations With oven door fully open To Replace Oven Door Changing Oven Light Storage Drawer Service Solutions to Common ProblemsAppliance must be accessible for Code error for exemple F11 Poor baking results Self-cleaning cycle does not workCleaning cycle Fan noise during cooking operation Protection Agreements Get it fixed, at your home or ours Cuisinière encastrable Garantie sur appareil Kenmore Emplacementdelaplaque de sérieTable des matières Enregistrement de l’appareil Carbone pourrait en résulter et l’appareil pourrait Entretien par l’usager-Ne réparez pas ou neLe faites, un empoisonnement au monoxyde de Ne modifiez jamais l’appareil, que ce soit en Mesures de sécurité importantes Fours autonettoyants Ne laissez jamais les brûleurs sans surveillance Instructions de mise à la terre Conversion au gaz propane Caractéristiques de l’appareil Four autonettoyant Avant de régler les commandes des brûleurs de surface Emplacement des commandes des brûleurs de surface Emploi des brûleurs de surface Réglage des commandes des brûleurs de surfaceRéglage de la bonne dimension de la flamme Type de cuisson Cuisson sur la table de cuisson Ustensiles pour la cuisson sur les brûleursUtilisation d’UN wok Position de l’évent Avant de régler les commandes du four suiteInstallation des grilles Enlever et replacer les grilles de four Réglage de la commande du four Fonctions des touches de la commande du four Réglage de la minuterie Pour un tableau de commande silencieuxRéglage de lhorloge Conversion de la température Pour régler la commande du four pour la cuisson au four Réglage de la fonction de verrouillage du fourPour régler la fonction de verrouillage Cuisson au four Lorsque la durée de cuisson programmée s’est écoulée Cuisson au gril Catégorie d’aliment Réglage de la fonction Garder ChaudMD Fonctionnement de la lampe du fourRéglage de la fonction Garder ChaudMD Prenez les précautions de nettoyage qui suivent Cycle autonettoyantNettoyage du four Préparation du four avant le cycle autonettoyant La fin du cycle autonettoyant Durée du cycle autonettoyantAjustement de la température du four Arrêt ou interruption d’un cycle autonettoyant Entretien général & nettoyage Entretien général & nettoyage suite 1er Pour enlever la porte du four Nettoyage de l’acier inoxydableEnlever et replacer la porte du four Pour replacer la porte du four Remplacement de l’ampoule du four Tiroir de rangement La commande du four sonne et Solutions aux problèmes les plus fréquentsFacilement. Il doit être accessible ’appareil n’est pas de niveau Durant la cuisson au gril Tion Réglage du four La flamme est orangeLe four dégage beaucoup de fumée Autonettoyant Contrats DE Protection Get it fixed, at your home or ours