Kenmore 385.15408 Extension Table, @ Tab, Changing Needle, To Remove and Attach the Foot Holder

Extension Table

•Detaching the table

Pull the table away from the machine, as illustrated, for "free-arm" sewing of cuffs and sleeves.

•Attaching the table

Push the extension table until it snaps into the machine. (_) Extension table

(_) Pin

(_ Holes

@ Tab

(_) Free-arm

Changing

Needle

(_ Needle clamp screw

(_)

Needle

clamp

[_Turn

off the power switch.

Raise the needle to its highest position by turning the

handwheel

counterclockwise,

toward

you. and lowering

the presser foot. Loosen the needle clamp screw_by

turning

it counterclockwise.

Remove

the

needle

from the

needle

clamp

(_).

[]

insert

a new

needle

nto

the

needle

clamp@with

the

flat side to the rear. When inserting the needle into the

needle clamp (_), push it up as far as it goes. Tighten

the needle clamp screw 1_ firmly by turning it clockwise.

[]

To

see

if the

needle

is good,

place

the fiat

side of

the

needle

onto something

flat (e.g needle plate or glass).

The

gap

between

the

needle

and

the flat

surface

should

be

consistent.

Never

use a bent or

blunt

needle.

A damaged

needle

can

cause permanent

snags

or runs

in knits, fine silks and silk-like fabrics.

To Remove and Attach the Foot Holder

_i_ Thumb screw _2_Foot holder _3_Presser bar

•To remove

Remove the thumb screw _1_by turning it counterclock- wise with a screwdriver.

•To attach

Match the hole in the foot holder _2_with the threaded hole in the presser bar _3_. Fit the thumb screw _i_ into the hole. Tighten the screw _1_by turning it clockwise with screwdriver.

I

/

J

=lat side

_ado Diane Needle

',4eclatAguja

Aiguille

f

J

\

f

10