Cleaning the Shuttle Race

This area must be keptfree of dust, lint and
occasional tangled thread. Clean the shuttle race area
about every three months
oCleaning the shuttle area
0 Bobbin case
(_) Levers
(_ Shuttle race cover
(_ Shuttle
(_) Shuttle race
(_) Center pin on the shuttle
1. Raise the needle bar to its highest point and remove the
bobbin case (_.
2 Push shuttle race levers (_) aside_ Lift shuttle race
cover (_ and take shuttle Qout,
3 Clean the shuttle race Q with a lint brush_
4 Put a drop of oil on the center pin of the shuttle (_) and
shuttle race(_) Donot over oil,
•Replacing shuttle assembly
(_ Levers
Shuttle race cover
Q Shuttle
(_) Shuttle race
_) Center pin on the shuttle
0 Shuttle driver
(_) Pointed hook
(_) (Oil here)
1.Turn handwheel so that shuttle driver (_ is forming half
moon on the left side of the machine,
2. Hold shuttle (_) by center pin (_ and position shuttle so as
to form a half moon on the right side, The pointed hook (_)
will be on the bottom
3. Place shuttle race cover 0 into place over shuttle
assembly,
4. Snap the levers (_ back into the original position
f
%
J
64