Threading the Machine
oThreading the machine
*Raise the thread take-up lever to its highest position by
turning the handwheel counterclockwise, toward you_
*Raise the presser foot lifter
*Place a spool on the spool pin, with thread coming off as
shown.
[] Draw the end of thread around the upper thread guide
[] While holding the thread near the spool, draw the end of
the thread down around the check spring holder,
[] Firmly draw the thread up from right to left over
the take-up lever and down into the take-up lever
eye.
[] Slidethe thread behind the needle bar thread guide on the
left
[] Thread the needle from front to back or use a needle
threader.
We recommend using the convenient needlethreader
(#200262101), included with your machine.

•Drawing up bobbin thread

[] Raise the presser foot. Hold the needle thread lightly with
your left hand and rotate the handwheel counterclockwise,
toward you, for one complete turn.
[] Bring the bobbin thread up bypulling the needle thread up.
[] Pull both threads under and to the back of the presser foot,
leaving 4 to 6 inches (10 cm to 15 cm) of thread clear.
[]
[]
[]
24