STEP 5: INSTALL THE MOUNTING PLATE TO THE WALL
TO PREPARE THE REAR WALL CUTOUT OPENING AND EXHAUST ADAPTOR/MOUNTING PLATE FOR WALL VENTING AND ROOF VENTING:
NOTE: If room vented installation is used, skip this step.
1.Place the mounting plate against the rear wall as described in step 5 item 1 (page 15).
2.Use the wall template to determine the location and size of the box cutout for the rear wall duct. See
Figure 28.
•Attach the exhaust adaptor to the rear mounting plate by sliding it into the guides at the top center of the plate on the wall side. Push in securely until it is past the top locking tabs and in the lower locking tabs. Take care to assure the damper hinge is installed so that it is at the top and that the damper swings freely.
•Carefully guide the exhaust adaptor, now attached to the Back of oven, into the house duct, before using the screws to attach the plate to the wall. This will assure proper alignment for installation. See Figure 29.
•Return to step 5, item 3 (page 15) to continue. After completing the installation of the Back of oven, again check the rear damper for free movement to assure it will operate properly.
Exhaust Adaptor
Slide exhaust
adaptor into guides on rear panel.
t
REARWALLTEMPLATE
Figure 28
Damper
(hinge side up)
Back of oven
(wall side)
ig
Tabs Guides
Figure 29
16