Kenmore 790.7936, 790.7937 manual Clean will flash, 300 hours Press, 200 to 400 using Number pads

Self-Cleaning

•Setting Flex Clean

•Setting Delay Flex Clean

The FLEX CLEAN @ pad is used to start a Self-Cleaning cycle. When used with the DELAY START @ pad, a

delayed Self-Cleaning cycle may also be programmed. The FLEX CLEAN feature allows for any Self-Cleaning cycle time from 2 (2:00) to 4 hours (4:00) to be selected. You may also choose the clean time in 1 minute increments (for example 2

hours and 50 minutes) by pressing the number keypads ___.

During the Self-Cleaning cycle, the outside of the range can become very hot to the touch. DO NOT leave

small children unattended near the appliance.

DO NOT force the oven door open. This can damage the automatic door locking system. Use care when

opening the oven door after the Self-Cleaning cycle. Stand to the side of the oven when opening the door to allow hot air or steam to escape. The oven may still be VERY HOT.

INSTRUCTIONS PRESS DISPLAY

To start an immediate Self-Cleaning cycle or to set a delay start time of 9:00 o'clockand shut off automatically (example provided is a default 3 hour Self-Clean cycle):

1.Be sure the clock is set with the correct time of day, the oven is empty and the oven door is closed.

v	. "CLEAN" will flash, "3:00" (hours) and the	@
2. Press _

Cooktop locked icon will show in the display (See Fig. 1). 2-4 hours of Self-Cleaning time may be choosen by pressing any

amountoftimefrom___(2hours)through

___ (4 hours) in one minute increments. You

may also skip the time entry and accept the default cleaning time of 3 hours by pressing the Start key pad (See Step 3).

3.Press _ .The "DOOR LOCKED" icon will flash; "CLEANI'

V

2:00 to 4:00 using Fig. 1

number pads

Fig. 2

Cooktop Lockout icon and the letters "CLn" will remain on in the display (Fig. 2).

Fig. 3

4. As soon as the control is set, the motor driven oven door lock will begin to close automatically. Once the door has been locked the "DOOR LOCKED" indicator light will quit flashing

NOTE: If the optional delay Self-Cleanfeature is needed, finish steps 5-7.If Self-Cleanis started immediately skip the remaining

steps and continue with "When the Self-Clean cycle is done" on the following page.

and remain on. The Cooktop locked icon will remain on (Fig. 3).

5.Press @ (See Fig. 4). Enter the desired Self-Clean starting

time using the number pads ___ (See Fig. 5).

6.Press _A'_. "CLn" icon will turn off; "DELAY", "DOOR LOCKED", "CLEAN" and Cooktop locked icons will remain on.

7.The control will calculate forward from the set start time to determine when the Self-Cleaning cycle should end. The Self- Cleaning cycle will turn on automatically at the set time. At that time the icon "DELAY" will go out; the oven icon will come on, the start time, Cooktop locked icon, "CLEAN" and "CLn" will remain in the display (See Fig. 6).

Fig. 4

Fig. 5

Fig. 6

33