Setting Oven Controls

Setting the Clock

Changing between 12 or24 hour display

Setting the Clock

The CLOCK _

pad is used to set the clock. The clock may be

set for 12 or 24 hour time of day operation. The clock has been preset at the factory for the 12 hour operation. When the range is first plugged in, or when the power supply to the range has been interrupted, the timer in the display will flash with power failure "PF" (See Fig. 1).

INSTRUCTIONS

To set the clock (example below for 1:30):

1. Press

_.

"CLO" will

appear

in the display

(Fig.

2).

.

(_(_(_

 

pads

to set the

time

of day

to 1_30

Press

 

(Fig. 3). "CLO"

will appear

in the display.

Press

(_.

"CLO"

will disappear and the clock will start (Fig. 4).

Fig. 1

PRESSDISPLAY

G

Fig. 2

Fig. 3

Changing between 12 or 24 hour time of day display:

1. Press and hold _

for 6 seconds (Fig. 3). While holding the

_for

6 seconds

pad down the current time of day will remain and "CLO" will disappear from the display (Fig. 4). CONTINUE holding the pad until "12 Hr"(Fig. 5) or "24 Hr" appears in the display.

2.Press @ to switch between the 12 and 24 hour time of day

display. The display will show either "12 Hr" (Fig. 5) or "24 Hr" (Fig. 6).

3. Press _

to accept the desired change or press _

to

reject the change.

4.Reset the correct time as described in To set the Clock above. Please note that if the 24 hour time of day mode was chosen, the clock will now display time from O:OOthrough 23:59 hours.

Fig. 4

Fig. 5

Fig. 6

17

Page 17
Image 17
Kenmore 790.7936, 790.7937 manual Setting Oven Controls, Setting the Clock, To set the clock example below for, Pressdisplay