Setting Oven Controls
Setting the Clock
Changing between 12 or 24 hour display
Silent Control Operation
Setting the Clock
The CLOCK _ | pad is used to set the clock. The clock may be |
set for 12 or 24 hour time of day operation. The clock has been preset at the factory for the 12 hour operation. When the range is
first plugged in, or when the power supply to the range has been interrupted, the dock in the display will flash (See Fig. 1).
Fig. 1
INSTRUCTIONS | PRESS | DISPLAY |
To set the clock (example below for 1:30):
1. Press | . "CLO" will appear in the display | (See | Fig. 2). | ||
|
|
|
|
| Fig. 2 |
, | Press |
| pads to set the time | of day to 1:30 | |
| (See | Fig. 3). Press _"_. | "CLO" will disappear | and | the clock |
| will start (See Fig. 4). |
|
| Fig. 3 | |
|
|
|
| ||
Changing between 12 or 24 hour time of day display:
1. Press and hold _ | for 6 seconds untill "12h" or "24h" | 6 seconds |
V | (_for | |
appears in the display. |
|
|
2.Press _cc_x,'to switch between the 12 and 24 hour time of day display. "12h" or "24h" will be displayed (See Figs. 5 or 6).
3. | Press | (_ | to accept | the desired | change or press O | to |
| |
| reject the change. |
| in To set the |
|
|
| ||
4. | Reset the correct time as described | clock | above. |
| ||||
| Please note that if the 24 hour time of day mode was chosen, |
| ||||||
| the clock will now display time from | 00:00 through | 23:59 | hours. | Fig. 6 | |||
Setting | Silent | Control | Operation |
|
|
|
| |
The DELAY START _and | FLEX CLEAN _ | pads control the Silent Control operation | feature. The Silent Control | |||||
operation feature allows the oven control to be operated without sounds or beeps whenever necessary. If desired the control can be programmed for silent operation and later returned to operating with all the normal sounds and beeps.
INSTRUCTIONS | PRESS | DISPLAY |
To change control from normal sound to silent control operation:
1.To tell if your range is set for normal or silent operation press
and hold d_for6 | seconds. (See Fig. 7) | _for | 6 seconds | Fig. 7 |
2.Press _c_a_ to switch between normal sound operation and
silent operation mode. The display will show either "SP" (See Fig. 8) or" =="(See Figs. 2 or 3).
Fig. 8
If "SP" appears (See Fig. 2), the control will operate with normal sounds and beeps. If" ==" appears (See Fig. 9), the control is set for silent operation mode.
3. Press @ | to accept the change or press Q to reject the | @orQ | Fig. 9 |
| |||
change. |
|
|
|
13
