Kenmore 790.7943 manual Before Using Your Range

Before Using Your Range

Assembly of Burner Heads & Burner Caps (for Deep Well Cooktop models only)

Your appliance is shipped with the Burner Heads and Burner between the Burner Heads and the cooktop.

a. Be sure to follow the installation instructions before installing and using your new appliance.

b. Remove all packing tape from cooktop area. Remove all Burner Caps and Burner Heads.

c. Discard all packing material located under Burner Heads. d. To replace Burner Heads & Caps, match the letters

located under center of Burner Caps with the letters located inside Burner Heads (Fig. 1).

e. Match the letters stamped on Burner Skirts with Burner Heads and Burner Caps (See Fig. 1). Replace the Burner Heads and Caps on cooktop (See Fig. 2). Carefully align the Electrodes into slot or hole of each Burner Head (Fig. 3). Note: The Burner Heads should sit flat on Cooktop Burner Skirts.

f. Unpack Burner Grates and position on the cooktop.

Caps in the correct locations. Packing material is located

Burner

Cap

Fig. 2

Fig. 1

Electrode

must align into slot or hole for Simmer Burner Head

Fig. 3