Setting Surface Contro&
Dual radiant surface element (some models)
To operate the dual radiant element:
1. Place correctly sized cookware on single radiant surface element.
2.Push in and turn the surface control knob clockwise to
begin heating both the inner and outer portions of the
element (marked dual - See Fig. 2). If only the inner
heating portion is needed (marked single - See Fig. 1) for
smaller cookware, push in and turn the knob counter-
clockwise to start.
Please note that you may switch from the single or dual settings at any time during cooking.
3.When cooking is complete, turn the radiant surface element OFF before removing the cookware.
Important notes:
°For efficient cooking, turn OFF the element several minutes before cooking is complete. This will allow residual heat to complete the cooking process.
°The surface control knobs do not have to be set exactly on a particular spot. Use the graphics provided as a guide and adjust the control knob as needed. Each surface element provides a constant amount of heat at each setting. Refer to the Suggested radiant surface element settings table for suggested power level settings.
°Start most cooking operations on a higher setting and
then turn to a lower setting to finish cooking.
Radiant elements have a limiter that allows the radiant heating element to cycle ON and OFF, even at the HI
setting. This helps prevent damage to the ceramic
smoothtop. Cycling at the HI setting is normal and will
occur more often if the cookware is too small for the
radiant element or if the cookware bottom is not fiat.
° A | glowing | red surface | heating | area | extending | beyond | |||
the | bottom | edge | of | the | cookware |
| indicates | the cookware | |
is | too small | for | the | surface | heating | area. |
| ||
@©
RJont Front | Right Front |
000
0
| Fig. | 1 | Fig. 2 |
Heating | with | inner | Heating with both |
(small) | element only | elements | |
Areas that heat are shown darkened.
Radiant surface elements may appear to have cooled after they have been turned off. The glass surface may still be hot and burns may occur if the glass surface is touched before it has cooled sufficiently.
Do not place plastic items such as salt and pepper shakers, spoon holders or plastic wrappings on fop of the range when it is in use. These items could melt or ignite. Potholders, towels or wooden spoons could catch fire if placed too dose to the surface elements.
Do not allow aluminum foil, empty glass/ porcelain cookware or ANY materlal that can melt to make contact wlfh the ceramic cookfop. If these items melt on the cooktop they may damage the ceramic cooktop.
12
