Before You Call • Solutions to common problems
ProblemSolution
Oven smokes excessively when broiling. ° Incorrect setting. Follow broiling instructions in Setting Oven Controls
section.
*Be sure oven door is opened to broil stop position when broiling.
* Meat too close to the broil element. Reposition the broil rack to provide
proper clearance between the meat & the element. Preheat the broil
element for searing.
°Meat not properly prepared. Remove excess fat from meat. Cut remaining fatty edges to prevent curling, but do not cut into lean.
*Grease has built up on oven surfaces. Regular cleaning is necessary when broiling frequently. Old grease or food spatters cause excessive smoking.
Flames inside oven or smoking from oven | * Excessive spillovers | in oven. | For example | this | will | happen | for | pie | ||||
vent. | spillovers | or large | amounts | of | grease | left | on | the oven | bottom. | Wipe up | ||
| excessive | spillovers | before | starting | oven. | If flames | or | excessive | smoke | |||
| are present | see Broil in Setting | Oven Controls | section. |
|
|
|
Oven control panel beeps & displays
any F code error,
Flex Clean does not work.
Soil not completely removed after Flex Clean.
[]
° Oven control has detected a fault or error condition. Press STOPkey pad to
clear the error code. Try Baize or Broil function. If the F code error repeats,
remove power from appliance, wait 5 minutes and then repower appliance
and set clock with the correct time of day. Try Baize or Broil function again.
If the fault recurs, press sToP to clear and call
*Oven control not set properly. Review instructions in Flex Clean section.
*Flex Clean was interrupted. Review instructions in Flex Clean section.
°Excessive spillovers on oven bottom. Remove before starting Flex Clean.
Failure to clean soil from the oven frame, the door liner outside the oven door gasket and the small area at the front center of the oven bottom.
These areas are not in the
on residue. Clean these areas before the
nylon scrubber. Be careful not to damage the oven gasket.
Oven racks discolored. | * | Oven | racks | left in | oven cavity | during Flex Clean. | Always remove oven | racks |
|
| from oven cavity before starting a | ||||||
|
| abrasive cleaner following manufacturer's instructions. Rinse with clean |
| |||||
|
| water, dry and replace in oven. |
|
|
| |||
Convection fan does not rotate. | ° | Oven | door | is open. | Convection | fan will turn off if | oven door is opened | when |
|
| Convection is active. Close oven door. |
|
|
37