Kenmore 790. 4788, 790. 4789 manual Setting the Clock, To set the clock example below for

Setting the Clock

Setting the Clock

The _ pad is used to set the clock. The clock may be set for 12 or 24 hour time of day

operation. The clock has been preset at the factory for the 12 hour operation. When the range is first plugged in, or when the power supply to the range has been interrupted, the timer in the display will flash with "PF" (power failure, See Figure 1).

When PF appears in the display, press __'), PF will disappear.

To set the clock (example below for 1:30)

INSTRUCTIONSPRESS

1. Press ('_-'_."CLO" will appear in the display (Figure 2).

0

2.Press (_ (_ (_ pads to set the time of day to 1:30 (!)@(5)

(Figure 3). "CkO" will stay in the display. Press "CkO"

will disappear and the clock will start (Figure 4).

Figure 1

DISPLAY

Figure 2

Changing between 12 or 24 hour time of day display

1. Pressandhold@for7seconds.After7seconds, "12h"(Figure

5) or "24h" (Figure 6) will appear in the display and the control will beep once.

2.Press _,,) to switch between the 12 and 24 hour time of day

display. The display will show either "12h" (Figure 5) or "24h" (Figure 6).

3.Press STARTto accept the change or press {:_,) to reject the change.

4.Reset the correct time as described in To set the Clock above. Please note that if the 24 hour time of day mode was chosen, the clock will now display time from 0:00 through 23:59 hours.

0

for 7 seconds

Q

or

Figure 3

Figure 4

Figure 5

Figure 6