II

BEFORE CALLING FOR SERVICE (cont.)

Washer won't

Control

panel is asleep

This is normal.

Press POWER.

operate

Washer

is unplugged

Make sure cord

is plugged securely into a working outlet.

Water supply is turned offTurn both hot and cold faucets fully on.

Controls are not set properlyMake sure the cycle was set correctly, close the lid and

press START.

Lid is open-safety feature prevents Close lid and reset cycle, to the beginning if necessary. the washer from filling and operation

when lid is up

Circuit breaker/fuse is tripped/blown Check house circuit breakers/fuses. Replace fuses or reset breaker. The washer should have a dedicated circuit.

Electronics need to be resetPress the POWER button, then reselect the desired cycle and press the START/PAUSE button.

START was not pressed after a Press the POWER button then reselect the desired cycle

cycle was set

and press the START/PAUSE button.

Extremely low water pressure Check another faucet in the house to make sure that household water pressure is adequate.

Washer is too cold

If the washer has been exposed to temperatures below

 

freezing for an extended period of time, allow it to warm up

 

before pressing POWER. Otherwise, the display will not

 

come on.

• Filter clogged or fill hoses may be

Washer not fillingkinked properly

• Energy efficiency

Make sure that filters (blue and orange screens must be free of solids) on the unit are not clogged. Refer to the filter cleaning instructions on page 24.

Check that fill hoses are not kinked or clogged.

This is an energy-efficient washer. As a result the tempera- ture settings for this washer may be different than non-energy-efficient washers.

• Insufficient

water supply

• Make sure that the water supply is turned on. Make sure

 

 

that the water faucets are turned to their completely open

 

 

positions.

• The washer

lid is open

• The washer lid must be closed for all washer cycle

 

 

operations. If the lid is opened during washer operation, all

 

 

functions will stop, including water filling.

• Incorrect fill hose connection

• Make sure that the fill hoses connect the hot water supply to

 

 

the hot inlet on the washer, and the cold water supply to the

 

 

cold inlet on the washer (hot to hot, cold to cold).

• Water fill optimization

• Water may not cover the top level of the clothes. This is

 

 

normal for this high-efficiency washer. The water fill is opti-

 

 

mized by the system for best wash performance.

29

II

Page 29
Image 29
Kenmore 796.292796 manual Make sure that the water supply is turned on. Make sure