Kenmore DU805DWG, DU910PFG, DU890DWG Be sure the door panel is inserted into the rear channel. Fig

IMPORTANT

Be sure the door panel is inserted into the rear channel. (Fig. 4-5)

11.Reinstall the two (2) access panel screws re- moved earlier to secure the access panel to the dishwasher. Tighten the right screw first, then the left.

Access Panel

Extension

(Fig. 4-5)

Access Panel

(Fig. 4-7)

Insulation

(Fig. 4-6)

Retainer

Trim Strip

(Fig. 4-8)

6. Place the access panel front side down. In- stall the metal access panel extension into the slot it the access panel by pushing down firmly until the extension snaps into place. (Fig. 4-7)

7.	Remove the adhesive backing from the ac-
	cess panel insulation and press the insula-
	tion firmly into place. (Fig. 4-8)
8.	Set the access panel upright. Slide the cus-
	tom panel down into the bottom and side slots.
	(Fig. 4-9)	(Fig. 4-9)

9. Secure the custom panel by inserting tabs on the panel retainer into the notches along the top back surface of the access panel. Press firmly on the forward edge of the retainer to snap it into place. (Fig. 4-10)

10.(Refer to Fig. 4-1 on page 71) Install the ac- cess panel assembly to the dishwasher by aligning the slots in the back flange of the extension over the two (2) screw heads pro- truding from the tow panel. Slide the access panel downward and tighten the screws.

Access Panel

Retainer

(Fig. 4-10)

57