Kenmore DU910PFG, DU890DWG, DU920PFG Removing the Water Inlet Valve, Removing the Thermal Fuse

Removing the Water Inlet Valve

1.Turn off the water supply to the dishwasher.

2.Turn the timer knob clockwise to the NORMAL WASH position to energize the water inlet valve and relieve water pressure in the line.

3.Turn the electrical supply to the dishwasher off and remove the toe panel and access panel. (Fig. 1-14)

Fig. 1-14

4.Disconnect the wiring harness connector from the water inlet valve terminals. (Fig. 1-15)

5.Disconnect the water lines from the water inlet valve.

6.Remove the Hex-head screw securing the water inlet valve to the tub support assembly.

Removing the Thermal Fuse

1.Turn the electrical supply to the dishwasher off and remove the toe panel and access panel.

2.Disconnect the orange and white wires from the thermal

fuse terminals. (Fig. 1-16)	THERMAL
	FUSE

3.Remove the Hex-head screw securing the thermal fuse

to the tub and remove the thermal fuse from the dishwasher.

Fig. 1-15

Fig. 1-16

WHITE

WIRE

RETAINING

SCREW

ORANGE

WIRE

Removing the Float Switch

1.Turn the electrical supply to the dishwasher off and remove the toe panel and access panel.

2.Remove the Hex-head screw securing the float switch

	to the tub. (Fig. 1-17)	FLOAT
3.	Lift the float from the housing inside the tub.	SWITCH
		HOUSING
4.	Unsnap the float switch housing cover and disconnect	RETAINING
	the two (2) wires from the terminals of the switch.		Fig. 1-17
	(Fig. 1-18)	SCREW

TERMINALS

WIRES

Fig. 1-18

SWITCH COVER

7