Kenmore DU850DWG, DU910PFG, DU890DWG, DU920PFG manual Custom Color Panels, Installation Instructions

Section Four

INSTALLATION CONSIDERATIONS

INSTALLING CUSTOM PANEL ACCESSORY KIT

Custom Color Panels:

Black	P/N 675775
White	P/N 675776
Almond	P/N 675777

Installation Instructions

In many instances, customers want to integrate the undercounter dishwasher appearance with overall kitchen design by installing panels of wood matching that used in the cabinets. After the two panels - an upper panel and a lower panel - are cut and finished as described below, use the materials in the Dishwasher Custom Panel Accessory Kit to install them by following the installation instructions.

Custom Panel Dimensions

NOTE: A ¼” thickness (actual 7/32”) can be used for wood panels. If using thicker material, edges must be routed to 7/32” as shown in box below.

Removing Access and Door Panels

1.	Loosen but do not remove the two (2) toe
	panel screws below the access panel. Re-
	move and set aside the two (2) screws above
	the access panel. (Fig. 4-1)
2.	Remove the access panel assembly by slid-
	ing it upward to clear the loosened screws.

18-21/32"

Upper panel

45ø

Min.

45 ø	Lower
Min.	panel

This access panel will be replaced by new a

new custom panel assembly. (Fig. 4-1)

3. Remove the two (2) screws from the bottom

of the outer door panel. (Fig. 4-1)

(Fig. 4-1)

7/32"

Max.

22-13/16" 1" Min.

	Required on
	top and bottom
4-7/16"	edges
	7/32" Max.

23-5/16"

1/4"

Min.

1/4"

Min.

CUTTING NOTES:

1.Custom panel for the door cannot exceed 8 lbs. weight.

2.The upper and lower panels are not the same width.

3.Match wood grain direction with that of adjacent cabi znets.

4.Sand panel edges to provide smooth finish.

5.IMPORTANT: Use moisture resistant sealer on both sides and all edges of the panels to protect from humidity. Dish washer is subject to humidity.

55