Kenmore DU920PFG, DU910PFG manual Removing the Timer, Removing the Switch Assembly, 23 Connector

Removing the Timer

1.Disconnect the dishwasher from the electrical supply and remove the toe panel and access panel from the bottom of the dishwasher and the inner door panel.

	Screw
2. Disconnect the wiring harness connectors from	Screw
the timer terminals. (Fig. 1-23)

3.Remove the three (3) Hex-head screws securing the timer to the door frame. (Fig. 1-23)The timer, cam and cam follower can now be removed.

Wiring Harness

Connector

Screw	Wiring
	Harness
Fig. 1-23 Connector

NOTE: When reinstalling the cam, be sure it is aligned with the keyed shaft of the timer. When reinstalling the timer, be sure the cam follower post is positioned inside the cam’s groove.

Removing the Switch Assembly

1. Disconnect the dishwasher from the electrical supply and remove the toe panel and access panel from the bottom of the dishwasher and the inner door panel.

2. Disconnect the harness wires from the spade connectors on the switch assembly. (Fig. 1-24)

3. Remove the two (2) Hex-head screws securing		Screw
the switch assembly to the door frame. (Fig. 1-24)
The switch assembly can now be removed.	Screw	Fig. 1-24

Removing the Door Latch Switches

1.Disconnect the dishwasher from the electrical supply and remove the toe panel and access panel from the bottom of the dishwasher and the inner door panel. (Fig. 1-25)

2.Disconnect the wiring harness connectors from the door latch switch terminals.

3.Unclip the handle and latch assembly from the door frame.

4.To remove the switches from the handle and latch assembly, push the two (2) retaining pins out of the holes and remove the switches.

SWITCHES

HANDLE &

LATCH

ASSEMBLY

RETAINING

PINS

Fig. 1-25

9