Kenmore DU800DWG, DU910PFG, DU890DWG, DU920PFG, GU960SCG, DU850DWG manual Servicing the Pump Assembly

4.Disconnect the drain hose from the drain valve by loosening the Hex-head screw on the hose clamp. (Fig. 1-7)

5.Disconnect the pump inlet hose from the pump and motor assembly. (Fig. 1-7)

6.Remove the pump and motor assembly from the bottom of the dishwasher.

PUMP INLET

HOSE

DRAIN

HOSE

Fig. 1-7

NOTE: Once the pump and mo- tor assembly has been removed from the tub, the pump outlet grom- met can be removed from the inside of the tub. Check the pump outlet grommet for wear or damage and replace it if necessary.

The motor can be removed from the pump assembly by removing the three T-20 Torx screws securing the motor to the pump assembly. (Fig. 1-8)

TORX

SCREWS

NOTE: When reinstalling the motor make sure the keyed motor shaft lines up with the pump impel- ler.

Fig. 1-8

Servicing the Pump Assembly
The pump impeller can be accessed by using
an adjustable slip-nut wrench to turn the
disk mount assembly counterclockwise.
Once the disk mount assembly is removed,
the impeller can be removed. (Fig. 1-9)		SLIP-NUT WRENCH
		TORX
	Fig. 1-9	SCREWS
The drain valve can be accessed by removing
the four (4) T-20 Torx screws securing the drain
outlet cover to the pump assembly. The drain
cover seal, diaphragm and diaphragm ring can
be removed and replaced. (Fig. 1-10)		Fig. 1-10

5