Kenmore DU920PFG, DU910PFG Removing Access and Outer Door Panels, Removing the Inside Door Panel

ACCESSING COMPONENT INSIDE THE DISHWASHER DOOR

Removing Access and Outer Door

Panels

1.Loosen but do not remove the two (2) toe panel screws below the access panel. Re- move and set aside the two (2) screws above the access panel. (Fig. 2-11)

2.Remove the access panel assembly by slid- ing it upward to clear the loosened screws. (Fig. 2-11)

3.Remove the two (2) screws from the bottom of the outer door panel. (Fig. 2-11)

4.Pull the bottom of the outer door panel out- ward and slide it down approximately ¼” to ½”. The panel will then be free for removal. (Fig. 2-11, inset)

5.Remove the existing door insulation. Access to the detergent and rinse aid dispensers is now possible.

Fig. 2-11

Removing the Inside Door Panel

1.Disconnect the dishwasher from the electrical supply.

2.Disconnect the end of the door springs from the door spring tension adjustment holes in the frame runner.

3.Open the dishwasher door and remove the eight (8) T-15 Torx screws securing the inner door panel from the door frame. (Fig. 2-12)

4.Slide the inner door panel back toward the dish- washer to disengage the spring loaded locking tab from the door panel, then lift the door panel away from the door. (Fig. 2-13)

T-15

TORX

Fig. 2-12

Inner Door

Panel

Fig. 2-13	Spring Loaded
	Locking Tab

4. Remove the control cover.

SLIDE INNER DOOR

PANEL TOWARD

DISHWASHER

31