Kenmore DP840DWG, DU910PFG, DU890DWG, DU920PFG, GU960SCG, DU850DWG manual Dishwasher Dispenser Assembly

Dishwasher Dispenser Assembly

1.Assembly the upper slide, slide spring and lower slide to the detergent door actuator. (Fig. 1-32)

2.Pass the detergent door latch lever through the panel making sure to turn the hook of the latch toward the detergent door. Snap the detergent door latch snap onto the door latch lever. (Fig. 1-31)

3.The door latch lever must pass through the opening in the lower slide. Press the actuator assembly into position until the upper and lower tabs engage.

4.Insert the diaphragm and diaphragm spring into the wet agent dispenser. Seat the diaphragm flush with the surface of the dispenser. (Fig. 1-30)

5.Install the upper and lower slides into the wet agent dispenser actuator.

6.Press the wet agent dispenser actuator into position on the dispenser so the lock-

ing tabs engage. Fig. 1-32

7.Press the wet agent dispenser assembly into position so the locking tabs engage the wet agent cap opening. No tool is needed for assembly. (Fig. 1-29)

8.Install the seal on the wet agent cap.

9.Insert the wet agent cap. Turn it clock- wise and close it.

10.Slide the upper and lower drawbars together. (Fig. 1-28)

11.Move all slides in both assemblies fully down. Keep the drawbars slid fully to- gether and align the drawbar holes over the locking tabs. Look behind the draw bars and make sure to engage the locat- ing tabs with their respective locating holes. Press the drawbars into position and slide them upward behind the locking tab ears. (Fig. 1-27)

12.Install the drawbar spring. (Fig. 1-26)

13.Install the drip cover by snapping it into place.

12