Kenmore DU890DWG, DU910PFG, DU920PFG, GU960SCG, DU850DWG, DP840DWG Servicing the Operating Thermostat

2.Disconnect the wiring harness from the motor harness plug.

3.Rubber clamps secure the pump and motor assembly to the tub. Rotate these inward 90°. (Fig. 2-7)

4.Remove the drain hose and clamp from the check valve and unscrew the check valve from the pump. (Fig. 2-8)

5.Remove the tuned sound absorber. Use an open-end wrench to loosen the shaft from the motor. Do not loosen the sound absorber by torquing on the large tuned resonator.

-- NOTE --

A small container will be required to catch water from the drain hose after removal.

Check Valve

Drain Hose

Clamp

Drain

Tuned Hose

Sound

Absorber

Clamp

Shown Rotated

Inward 90°

Fig. 2-7 Fig. 2-8

6. Remove the pump and motor assembly by pulling up through the inside of the tub. (Fig. 2-9)

Fig. 2-9

Servicing the Operating Thermostat

The operating thermostat is secured to the bottom of the pump housing. (Fig. 2-10)

1.Disconnect the two (2) wiring harness leads from the terminals on the thermostat.

2.Remove the two (2) Hex-head screws

securing the thermostat to the pump housing. Operating

Thermostat Fig. 2-10

30