Preparation

How to attach/detach the faceplate

Do not expose the faceplate to direct sunlight, excessive heat, or humidity. Also avoid places with too much dust or the possibility of water splashing.

Keep the faceplate in its casing while detached.

The faceplate is a precision piece of equipment and can be damaged by shocks or jolts.

To prevent deterioration, do not touch the terminals of the unit and faceplate with your fingers.

How to reset your unit

If this unit fails to operate properly, press the reset button.

The unit returns to factory settings when the reset button is pressed.

Reset button

How to prepare the remote controller (RC-40S)

When you use the remote controller for the first time, pull out the insulation sheet.

~o 0O(Q) 0000 OOO(Q)

Iii.

If the effectiveness of the remote controller decreases, replace the battery.

CR2025B

~It..

'0:1

CALIFORNIA, USA ONLY

This perchlorate WARNING applies only

to the product sold or distributed in

California USA "Perchlorate Material-special

handling may apply, See www.dtsc.ca.gov/

hazardouswaste/perchlorate:'

Caution:

Do not set the remote control in hot places such as on the dashboard.

Lithium battery.

Danger of explosion if the battery is incorrectly replaced. Replace only with the same or equivalent type.

The battery pack or batteries shall not be exposed to excessive heat such sunshine, fire or the like.

Keep battery out of reach of children and in original package until ready to use. Dispose of used batteries promptly. If swallowed contact physician immediately.

3

Page 3
Image 3
Kenwood KDC-248U instruction manual Preparation, How to attach/detach the faceplate, How to reset your unit