S T E P 1

Shut off lamp time

This option turns off the scanner lamp, which is otherwise continually on while the power is on, to save power if it remains idle for a specified length of time. It can be set to any interval of 4 minutes between 4 and 56 minutes (the actual shut off time may vary slightly from the specified interval). This setting is automatically set to 12 minutes when Plug-in Module CS-U is first installed.

Click the up or down arrow in the spinbox to increase or decrease the number setting or enter a number directly into the entry box

Reset Default Settings

Returns the preference settings and all other settings to the factory default settings. The tables list the major default settings.

Scan Mode

24bit Color

Magnification

100%

Unit

Pixels

Basic Resolution(Platen)

72 dpi

Basic Resolution(Film)

600 dpi

Control Panel Position

Center

Image

Recommended

Unsharp Mask

On

Descreen

Off

Shut of Lamp Time

12minutes

Film Type

Color Negative

Close Plug-in After Scan

This setting determines whether or not Plug-in Module CS-U closes automatically after completion of the scanning job. After you install Plug-in Module CS-U, this setting is set to off. To turn this feature on, open the [Preferences] menu and select [Close plug-in after scan].

Platen/Film

When a film adapter unit (FAU-S12/S13) is attached to the scanner, the [Film] option in the pull-down menu can be selected. Select either [Platen] or [Film] to make the respective scanning method effective, which is indicated by a check mark in the pull-down menu.

Caution

• When switching between the [Platen] and [Film] options, the scanner has to adjust the lamp output, which may require a few moments to take effect.

27

Page 27
Image 27
Canon 4.1 manual Shut off lamp time, Reset Default Settings, Close Plug-in After Scan, Platen/Film