desired position.
The 4 button moves the cursor to the left, and the ¢ button to the right.
You can also move the cursor left or right by pressing the TRACK+ or TRACK– buttons, respectively, on the remote control.
4Each time the 38 button is pressed, the characters to be
entered change as listed below.
Press the DISC+ or DISC– button to display the desired character.
Characters that can be displayed are as follows.
Alphabet (upper case): A ~ Z
Alphabet (lower case): a ~ z
Numerals and symbols: 1~9 0 @ ” ‘ ` % & ∗ + - = , . / \ < > [ ]
Special characters: á à é è í ì ó ò ú ù Ñ ëî ï ô ö û ü ñ ç © Æ ›
NOTE
The operation and characters that can be entered may change as listed below, depending on the unit that is connected.
A press of the 38 button exits the disc name preset mode. Operations can be followed again from Step 2 at a time such as this, and the characters to be input are selected using the procedure described below.
Press the DISC+ or DISC– button to display the desired character. Besides the alphabet (capital letters only) and numbers, you can choose the following characters: /, +,
5Continue steps 3 and 4 until all the characters are chosen for the name.
6Press either the NAME.S button on the main unit or the OK button on the remote control.
The disc name is stored and the disc name preset mode is cancelled.
If you make no entry in a
NOTE
•The number of characters and discs whose names can be stored will differ depending on the disc changer that is connected. Please see your disc changer manual for details. Up to 8
•Discs are identified by their total length and number of tracks. If another disc happens to have the same specifications as one that you have already stored a name for, the name will be displayed for it, too.
•If you want to change the name of a disc, repeat steps 1 and 2 to display the name, and then repeat steps 3 and 4 to input the changes.
•Pressing the reset button erases the disc names stored in this unit, but does not erase the names stored in a disc changer.
— 25 —