Recalling a Preset Station:
Press the preset station button
Station Name Preset (SNPS)
You can assign names to radio stations with the Station Preset Memory. Up to 32 FM stations and 16 AM stations can be assigned names.
1Adjust the frequency to the station whose name you want to enter.
2Press the NAME.S button for at least two seconds.
"NAME SET" is displayed once the station name preset mode is entered.
The cursor will blink in the position where letters are entered.
3Press either the 4 or ¢ button to move the cursor to the desired position.
The 4 button moves the cursor to the left, and the ¢ button to the right.
4Each time the 38 button is pressed, the characters to be entered change as listed below.
Press the FM or AM button to display the desired character. Characters that can be displayed are as follows.
Alphabet (upper case): A ~ Z
Alphabet (lower case): a ~ z
Numerals and symbols: 0~9 @ ” ‘ ` % & * + - = , . / \ < > [ ]
Special characters: á à é è í ì ó ò ú ù Ñ Ç ® ß ‹ fl â ä ê ë î ï ô ö û ü ñ ç © Æ › fi
5Continue steps 3 and 4 until all the characters are chosen for the name.
NOTE
You can enter up to eight characters for each name.
6Assigning Names
Press the NAME.S button.
The name of the station is stored in memory, and the Station Name Preset mode ends.
Also, if you make no input for 10 seconds, the name will be stored up to the point that you have entered, and the mode ends.
NOTE
•You can assign names to up to 32 FM stations and 16 AM stations.
•All the station names will be erased if you press the Reset button.
•If you want to change the name of a station, first display the name of the station (following steps 1 and 2 above), then change the letter(s) that you want by following steps 3 and 4.
Switching Display for Tuner
You can change the display used when listening to the radio.
Changing the Display:
Each time you press the DISP button, the display changes as follows:
Station frequency
SNPS name (only when being preset)
— 17 —
