Basic operations of remote (See page11)

English

2CAUTION

Do not set the remote on hot places such as above the dashboard.

Replacing the Lithium Battery:

Use one lithium battery (CR2025).

Remove the case following the instructions as illustrated.

To open

1 Keep on slide 1 2 Pull out.

2

Insert the battery with the + and – poles aligned properly, following the illustration inside the case.

2WARNING

Store unused lithium batteries out of the reach of children. Contact a doctor immediately if the battery is accidentally swallowed.

All Modes

•VOL. buttons

Press the u button to turn the volume up. Press the d button to turn the volume down.

•TUNER button

Selects the tuner mode. Pressing this button again selects the standby mode.

•CD button

Selects the CD mode.

•CD•MD CH button

Selects the disc changer mode. When two disc changers are connected to the unit, the disc changer mode will be split into disc changer mode 1 and disc changer mode 2, and each press

of this button switches between them.

NOTE

The KCA-S200, which is sold separately, must be used when two disc changer units are connected.

When the KDC-C810 is the directly connected disc changer (disc changer 1), two units may be controlled even without the KCA- S200.

Tuner Mode

•Number/ letter entry buttons

Press buttons #1-6 to recall preset stations.

During direct access tuning, use these buttons to input the frequency of the station.

Use to enter letters (alphabetical) during station name preset.

•TUNE buttons

Press the TUNE– button to make decreasing seeks (using the

preset tuning mode).

Press the TUNE+ button to make increasing seeks (using the preset tuning mode).

Use to move the cursor left or right during station name input.

•AM/FM button

Press the AM button to select the AM band.

Press the FM button to select and switch between FM1, FM2, and FM3 bands.

During station name input, selects digits and symbols.

•DIRECT/OK button

Selects the direct access tuning mode, used to input frequencies directly. Press this button again to cancel the mode while it is operating.

During station name input, stores the already input data in memory and ends the input mode.

During Station name preset play mode, selects station.

•DNPP button

Enters and cancels the Station Name Preset Play mode.

14