Station Name Preset (SNPS)

You can assign names to radio stations with the Station Preset Memory. Up to 25 FM stations and 8 AM stations can be assigned names.

1Adjust the frequency to the station whose name you want to enter.

2Press the NAME.S button for at least two seconds.

“NAME SET” is displayed once the station name preset mode is entered.

The cursor will blink in the position where letters are entered.

3Press either the 4 or ¢ button to move the cursor to the desired position.

The 4 button moves the cursor to the left, and the ¢ button to the right.

You can also move the cursor left or right by pressing the 4 or ¢ buttons, respectively, on the remote.

4Press the FM or AM button to display the desired character.

Besides the alphabet (capital letters only) and numerals, you can choose the following characters: /, +, –, *, =, <, >, [ and ].

NOTE Direct Input

Direct input can made of letters (alphabetical) with the letter entry buttons on the remote.

Example: Use the following table to enter the name "DANCE".

Character

Button to press

# Times pressed

 

 

 

“D”

#3

1

 

 

 

“A”

#2

1

 

 

 

“N”

#6

2

 

 

 

“C”

#2

3

 

 

 

“E”

#3

2

 

 

 

5Continue steps 3 and 4 until all the characters are chosen for the name.

NOTE

You can enter up to 8 characters for each name.

6• Assigning Names

Press the NAME.S button on the unit or the OK button on the remote.

The name of the station is stored in memory, and the Station Name Preset mode ends.

•Assigning Name and Storing Frequency with Station Preset Memory

Hold down the desired preset button for at least two seconds.

The name of the station is stored and the frequency for the current station is stored in the selected preset button. The Station Name Preset mode ends.

Also, if you make no input for 10 seconds, the name will be stored up to the point that you have entered, and the mode ends.

NOTE

•You can assign names to up to 25 FM stations and 8 AM stations. If you try to enter more than that, the station name stored the earliest will be the first one erased.

However, the station names stored in the preset button will be retained in the memory preferentially.

•All the station names will be erased if you press the RESET button.

•If you want to change the name of a station, first display the name of the station (following steps 1 and 2 above), then change the letter(s) that you want by following steps 3 and 4.

•You cannot assign names to RBDS stations.

English

17