Kenwood KDC-PS907 Removing the Unit, ■Removing the Unit

English

Removing the Unit■Removing the Unit

1Refer to the section “Removing the hard rubber frame” (p.34) and then remove the hard rubber frame.

2Remove the hex head machine screw with washer (M4⋅8) on the back panel.

3Insert the two removal tools at an angle and push them deeply into the slots on each side, as shown.

Accessory4

Accessory3

Removal tool

4Push downward on the left- hand tool and the upward

on the right-hand tool, as shown, and pull the unit toward you until it is halfway out. The unit may drop if you pull it out completely.

2CAUTION

Be careful to avoid injury from the catch pins on the removal tool.

5Pull the unit all the way out with your hands, being

careful not to drop it.

36