Manuals / Brands / Home Audio / Speaker / Kenwood / Home Audio / Speaker

Kenwood LSF-1010 Important Operating Notes

1 26

Download 26 pages, 437.31 Kb

LSF-1010 (EN)

DEUTSCH

FRANÇAIS ESPAÑOL

NEDERLANDS ITALIANO

Important Operating Notes

Satellite Speakers

1. The satellite speakers have a nominal impedance of 6 ohms. To ensure safe

and efficient speaker operation, be sure that your amplifier or receiver is able

to work with 6-ohm speakers.

2. The speaker system’s power capacity is indicated in the specifications. Do not

operate speakers at power levels above this limit. Doing so may result in dam-

age to the speakers.

1. If supplying a high-level signal, do not over-boost the bass at the amplifier or

receiver side. (Avoid excessive use of the amp’s bass control and other loud-

ness adjusters.)

2. Turn the subwoofer volume to its minimum level when making major changes

to the sound input (for example, when first switching on the amplifier or when

first dropping the needle onto a record).

Subwoofer

Contents

Main Before applying power Caution : Read this section carefully to ensure safe operation. Introduction Safety precautions Caution : Read this section carefully to ensure safe operation. WARNING : TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. Unpacking Introduction Contents IMPORTANT SAFEGUARDS Caution : Read this page carefully to ensure safe operation. IMPORTANT SAFEGUARDS Location and Orientation Attaching the Cushions Satellite Speakers Subwoofer Location and Orientation Location Precautions Interference with AM Reception Subwoofer and Satellite Speaker Magnetic Shielding and TV Color Reception Feedback (Howling) CAUTION (SUBWOOFER only) Setting Up the Satellite Speakers 1. Attach the speaker to the arm. FIRST: Attach speaker cord. Adjusting the Speaker Angle 2. Attach the arm to the stand. Setting Up the Satellite Speakers Before Connecting... Making Connections Subwoofer 1. If your amp or receiver includes a SUBWOOFER PRE- OUT jack: 2. If your amp or receiver does not include a SUBWOOFER PRE-OUT jack: 3. If your amp or receiver includes standard PRE-OUT jacks: Connecting to Amp's SUBWOOFER PRE-OUT Jack Do not plug in the power cord until you have finished mak- ing all connections. Connecting to Amp's Speaker Output Terminals IMPORTANT Connecting to Amp's Standard PRE-OUT Jacks Note About Pin-Plug Cables Components and Their Functions Subwoofer Adjusting the Sound 1. Adjusting the Volume 2. Adjusting the Turnover Frequency Important Operating Notes Satellite Speakers Subwoofer Getting Ready to Adjust 1. Remove the screw cap covering each arm screw. Adjusting the Satellite Speaker Position 2. Loosen the two screws. Adjusting the Arm Height 3. Replace the screw caps. Adjusting the Satellite Speaker Position Adjusting the Arm Angle 2. Set the arm holders to the desired angle. 3. Insert and fasten the arm. Offset Mount Other Ways to Set Up the Satellite Speakers 2. Set the arm holder to vertical position. 3. Attach and fasten the arm. Wall Mount 2. Set the arm holders to the desired angle. 3. Attach speaker cord to the base. 4. Reattach the clip to the pole. 5. Attach and fasten the arm. 6. Mount the stand onto the wall. Clip-on Mount 2. Clamp the clip onto an appropriate object. 3. Attach and fasten the arm. Maintenance Cleaning Contact Restorers 2- 1- Troubleshooting Specifications Subwoofer Satellite speaker