Kenwood LSF-1010 4. Reattach the clip to the pole., 5. Attach and fasten the arm., 6. Mount the stand onto the wall.

LSF-1010 (EN)
20
DEUTSCH FRANÇAIS
ESPAÑOL ITALIANO NEDERLANDS
2Attach supplied cushions to the bottom
of the stand base.
• The cushions will create a gap between
the wall and the base through which
speaker cord can pass. Please do not
neglect to attach the cushions.
4. Reattach the clip to the pole.
1First adhere the non-slip sheet onto the
pole.
• Wrap the sheet around the pole as
shown in the illustration.
2Attach the clip to the stand.
• Fit the clip securely onto the pole in the
position shown in the illustration.
Other Ways to Set Up the Satellite Speakers
5. Attach and fasten the arm.
1Fit the arm through the holes in the arm
holders, adjust it to the desire height,
and then tighten the arm screws.
2Place the screw caps back over the arm
screws.
3Reconnect the speaker cord to the jack.
You may now want to readjust the angle of the speaker on the arm. You can do
this by loosening the screw holding the speaker to the arm, repositioning the
screw, and then retightening it. See “Adjusting the Speaker Angle,” on page 8.
6. Mount the stand onto the wall.
1Screw a wall screw into the location
on the wall where you want to mount
the speaker. Allow the head of the
screw to project 4 to 6 millimeters
(about 3/16 to 1/4 inch) from the sur-
face of the wall.
• Wall screws are not included.
2Mount the base onto the wall by fitting
the mount hole (on the bottom of the
base) over the projecting screw head.
Be sure that the base is mounted se-
curely.
Cushions
Sheet
Mount hole